You are here: Getting Help > Safety and Notices > RF Exposure Information and Specific Absorption Rate (SAR) Information

RF Exposure Information and Specific Absorption Rate (SAR) Information

The following topics detail the specific absorption rate (SAR) information, electromagnetic safety information, and radiofrequency (RF) exposure information for this device.

This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States.

During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage against, and near the body with the separation of 5 mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Safety and Notices 90

The exposure standard for wireless employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.

Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.

The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of https://www.fcc.gov/general/fcc-id-search-page after searching on FCC ID: XHG-U772S

More information on the device's SAR can be found from the following FCC website: https://www.fcc.gov/general/fcc-id-search-page.

While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement.

Body-Worn Operation

Please note this important safety information regarding radio frequency (RF) radiation exposure and near-body operation. To ensure compliance with RF exposure guidelines, the device must be used at least 5 mm from your body. Failure to observe this warning could result in RF exposure exceeding the applicable guideline limits.

Specific Absorption Rate (SAR) Information

The following is a table of the maximum SAR values as observed on the U772.

Band

Channel

Maximum SAR Value

LTE Band 25

26365

1.17W/Kg

PCS 1900

1175

1.16W/Kg

Cellular 800

1013

1.06W/Kg

Secondary 800

564

1.1W/Kg