When is Your AIRAVE Ready for Use?

After installing and turning on your AIRAVE for the first time, it goes through an automated setup sequence. See the table below.

During this time, the device’s green LEDs will be solid for a few seconds, and then all LEDs, except the Broadband LED, will turn off until the software loads. This process may take up to 2 hours.

When the Broadband, GPS, Network, and Mobile LEDs are solid green, your AIRAVE is ready for use.

Note: For a summary of LED status indicators, see LED Quick Reference. For complete descriptions of LED states, see Using LEDs.

Tip: You will hear three short beeps when placing or answering calls on your wireless phone if you are within range of the AIRAVE.

The following table shows the LED startup sequence.

Broadband

GPS

Network

Mobile

AIRAVE State